2.2.2 Wiring harnesses
From G503Wiki
Back to the Ford GPW Judging Standard Index Page!
2.2.2 Wiring harnesses
GPW wiring consisted of lacquered, cotton insulated wire assembled into harnesses wrapped with shiny black harness tape. The terminals were soldered and the solder joints were covered with short (1”) sections of black rubber tubing. Modern plastic wiring is not acceptable and its use should result in full deduction of wiring points. Original wiring colors were muted, watch out for overly colorful reproduction wiring.
The left front fender (headlamp) wiring harness is shielded for radio suppression. The shielding should be of tinned copper, neatly applied with a cable loom machine. Slip-over shielding braid is not correct.
Updates to this info below this line
enter your info here...
